Instec Filters

Benefits of Instec Filter Designs

Get PDF versionElectromagnetic interference is defined as any unwanted electrical signal that is radiated or conducted into or out of the electrical equipment, which may disrupt the normal operation of the equipment. EMI can be continuous or intermittent.

Interference Suppression: Filters suppress electromagnetic interference in two basic ways.  The capacitive elements shunt the interference to ground and the inductive elements raise the impedance of the line, making the shunt capacitors even more effective.

Capacitor Elements: Instec filters are manufactured using MLC discoidals.  These robust capacitors provide optimum filtering and are preferred when compared to chip or leaded MLC capacitors and tubular capacitors .  MLC discoidal caps have multiple electrodes and offer extremely low impedance due to the through-hole design of the discoidal cap providing infinite paths to ground.  The discoidal design offers significantly lower inductance than leaded capacitor filters, lower impedance paths to ground than chip capacitor filters, and are much more robust in design than tubular capacitor filters.  Discoidal caps design also effectively prevents radiation from the input coupling directly with the output of the capacitor, unlike leaded or chip capacitors used as filters. The combination of low impedance, low inductance, and input/output isolation provides excellent shunting of EMI for frequencies up to and beyond 1 GHz.

Instec discoidal caps also give the following advantages:

  • Highest capacitance to volume ratio of the filter caps mentioned above.
  • Lowest impedance at higher frequencies.
  • Superior strength to tubular capacitors under both mechanical and thermal stresses.

Instec offers filters in various configurations as well as custom solutions.  Selection of the proper filter for the application is key to achieving the best overall performance.  Our design and technical teams are available to assist in this selection.

Resin Sealed Filters: Instec Resin Sealed filters offer a wide variety of packages and sizes.  These range from gold plated solder-in filters (610 Series) to 12-32 thread silver plated  bolt filters (650 Series).  The solder-in filters offer very low profile and narrow diameter filtering and are ideal for multi-circuits or filter plates where tight spacing is required.  If the filters are to be used in a filter plate, Instec has a fine-tuned assembly process that can be used to assemble your filter plates.  We are also set up to do 100% electrical screening and visual inspection on filter plates so your assembly yields would be pushed back to Instec.

The various sizes of bolt filters are ideal where higher current ratings are required or where inductive elements need to be introduced to the filter. All bolt filters ship with the required mounting hardware.

benefitNote re. 610 Series solder-in filters:  Instec solder-in filters have a hermetic seal on one side and the discoidal is soldered 360˚ around the OD.  This combination, in effect, gives a hermetic seal with the chassis, wall or plate.

Hermetic Filters: Instec Hermetic filters utilize glass seals to achieve hermeticity and are ideal for applications where rugged, sealed filters are required.  Internal designs consist of combinations of capacitors and inductors (ferrite beads or wire-wound inductors) in ¼-28 or 5/16-24 threaded cases. Given their larger sizes, very high capacitances can be achieved and higher current ratings are possible.  Filter performance can be tuned to match the application by choice of inductors.

Filter plates, custom assemblies, and solutions:  Instec designers can work with your engineers to design custom solutions or to give you outsourcing options for your filter assemblies.

Gowanda Components Group
Gowanda Components Group Gowanda Electronics Dyco Electronics Butler Winding Communication Coil TTE Filters Microwave Circuits Instec-Filters
www.GowandaComponentsGroup.com

Copyright © 1995-Present Instec Filters

All rights reserved. — Privacy Policy | Terms of Usage

1.716.532.2234 (T) - 1.716.532.2702 (F)

sales@instec-filters.comdesign@instec-filters.com